Friday, February 24, 2012

Controls and instrumentation - Engine thrust

want to read about : Controls and instrumentation - INSTRUMENTATION


  Engine thrust
10. The thrust of an engine is shown on a thrust- meter, which will be one of two basic types; the first measures turbine discharge or jet pipe pressure, and the second, known as an engine pressure ratio (E.P.R.) gauge, measures the ratio of two or three parameters. When E.P.R. is measured, the ratio is usually that of jet pipe pressure to compressor inlet pressure. However, on a fan engine the ratio may be  that of integrated turbine discharge and fan outlet pressures to compressor inlet pressure.
Fig. 12-3 Electro-mechanical E.P.R. transmitter.
11. In each instance, an indication of thrust output is given, although when only the turbine discharge pressure is measured, correction is necessary for variation of inlet pressure; however, both types may require  correction  for  variation  of  ambient  air temperature.  To  compensate  for  ambient atmospheric  conditions,  it  is  possible  to  set  a correction figure to a sub-scale on the gauge; thus, the minimum thrust output can be checked under all operating conditions.
12. Suitably  positioned  pilot  tubes  sense  the pressure or pressures appropriate to the type of indication being taken from the engine.  The pilot tubes are either directly connected to the indicator or to  a  pressure  transmitter  that  is  electrically connected to the indicator.
13. An  indicator  that  shows  only  the  turbine discharge pressure is basically a gauge, the dial of which may be marked in pounds per square inch (p.s.i.), inches of mercury (in. Hg.), or a percentage of the maximum thrust.

14. E.P.R.  can  be  indicated  by  either  electro- mechanical or electronic transmitters. In both cases the inputs to the transmitter are engine inlet pressure (P1) and an integrated pressure (PINT) comprised of fan outlet and turbine exhaust pressures. In some cases either fan outlet pressure or turbine exhaust pressure are used alone in place of PINT.
15. The  electro-mechanical  system  indicates  a change in pressure by using transducer capsules (fig. 12-3)

 to deflect the centre shaft of the pressure transducer causing the yoke to pivot about the axis A.A. This movement is sensed by the linear variable differential transformer (L.V.D.T.) and converted to an a.c. electrical signal which is amplified and applied to the control winding of the servo motor.
16. The servo motor, through the gears, alters the potentiometer output voltage signal to the E.P.R. indicator and simultaneously drives the gimbal in the same direction as the initial yoke movement until the L.V.D.T. signal to the motor is cancelled and the system stabilizes at the new setting.
17. The  electronic  E.P.R.  system  utilizes  two vibrating cylinder pressure transducers which sense the engine air pressures and vibrate at frequencies relative to these pressures. From these vibration frequencies electrical signals of E.P.R. are computed and are supplied to the E.P.R. gauge and electronic engine control system (Part 10).

2 comments:

  1. Thank You for the sharing the information with us , it helped me to understand Electronic Instrumentation and Control

    ReplyDelete
  2. Try online learning apps for control and instrumentation doubts! best learning app for engineering students and professionals!

    ReplyDelete